"Slop Stop 2.0" - Removes the play between MFT table guide and rail

Festool's multifunctional table (MFT for short) inspires many users. However, it also causes great frustration for many.

When everything is new, it's not so noticeable – but over time, the play between the guide pin at the support angle and the guide rail groove increases. The result is cuts that can exhibit a deviation of 0.5 to 1° across the entire length. While you could adjust the rail slightly, the problem recurs after a short time.

This little helper corrects precisely this problem. You can simply fix it in the rail groove with two screws.

The support unit leaves a natural mark on the underside of the guide rail. Set the "Slop-Stop" up to this mark and after the first tests you will see that it sits better and more precisely than before.

Of course, this plastic part can also wear out, but you have the option of replacing the plastic part 12 times.

Details on the General Product Safety Regulation (GPSR)

Manufacturer / producer

Mike's Toolshop GmbH
Industrial Estate 6
5121 Ostermieting

Phone: +43 6278 93080
Email: mail@mikestoolshop.at

Distributor / dealer

Mike's Toolshop GmbH
Industrial Estate 6
5121 Ostermiething
Austria

Phone: +43 6278 93080
Email: servus@mikestoolshop.at

From the date of delivery you have a 24-month statutory warranty .

Cutting tools, wearing parts and operating materials are excluded from the warranty, as their service life depends on the respective use, storage and/or intensity of use.

Warranty claims can only be asserted in the case of production errors or verifiable defects.

Here you can find more information about the warranty: https://www.oesterreich.gv.at/themen/gesetze_und_recht/verbraucherschutz/Gewährleistung-und-Verbraucherschutz.html